Cleaning a Bosch dishwasher

Maintaining the cleanliness of your Bosch dishwasher is crucial to preserving its lifespan and functionality. Food fragments, oil, and mineral deposits can accumulate inside the machine over time, producing foul odors and ineffective cleaning.

Not only does routine cleaning guarantee spotless dishes, but it also averts possible problems such as blockages and inadequate drainage. Thankfully, maintaining a Bosch dishwasher is a simple procedure that takes little time or energy.

This post will guide you through the process of cleaning your Bosch dishwasher correctly, from clearing out debris to removing tough limescale buildup. You can maintain the smooth and effective operation of your dishwasher by following these easy tips.

Get ready to remove dirt from the dishwasher

Consumers frequently have faith that specialized household chemicals can effectively remove any dirt from the dishwasher. It is said to be sufficient to simply load the detergent, initiate an idle working cycle, and watch it finish.

While some results may be obtained from this type of washing, it is not ideal as household chemicals are unable to fully remove debris from the drain filter or dirt from the machine’s blades. As a result, you must routinely clean the equipment by hand, making sure to take the following preparatory actions:

• disconnect the equipment from all communications;
• take out all the baskets for dishes so that they do not interfere during cleaning;
• remove the sprayers.

Generally speaking, cleaning should be done in the dishwasher at least once every one to two weeks, depending on how frequently it is used.

Additionally, gather the supplies you’ll need before beginning the wash: dishwashing liquids, soft-bristled brushes, an extra toothbrush, dry rags, and a basin to dilute detergents in. After completing the aforementioned preparations, use a damp sponge to wipe the machine chamber walls to get rid of any large contaminants or food particles that may have adhered to the device.

We will wash the door sealing rubber

Let’s start by taking care of the sealing rubber, which is situated between the home appliance’s body and door. Washing this rubber element at least once every six months is necessary to prevent it from getting too dirty. You can wash it with a damp sponge and a drop of detergent if it’s still relatively clean and hasn’t had time to accumulate ingrained dirt. Then, you can treat it with clean water.

For washing the rubber, avoid purchasing household chemicals that contain alkali or acids. If you do, the rubber seal will become less elastic and the machine will start to leak through the door while it is operating. It is preferable to wash the element at home with an old toothbrush if it got dirty while it was in use. Carefully clean it with a specific detergent after applying all the dirt.

Taking care of the rocker arms

The next task is to take care of the rocker arms, which still become clogged even though they are not in contact with the dishes while being washed. The truth is that scale builds up in the components and that food particles and fat actively find their way into the holes that allow water to enter the chamber. To clean them, adhere to these guidelines:

• add detergent to the previously prepared container, dilute it with hot water;
• add dirty elements of the dishwasher to the container;
• wait about 10 minutes;
• wipe the rocker arms with a soft sponge;
• you can additionally clean the holes with a toothpick;
• remove scale, grease and any other dirt from the axles on which the blades are installed.

Once the process is finished, you can use your hands to rotate the rocker arms to see if they rotate smoothly. After cleaning all debris from the moving components, place them in their designated slots.

To keep a Bosch dishwasher operating at peak efficiency and prolonging its life, cleaning is necessary. Frequent cleaning keeps food particles, oil, and limescale from accumulating and guarantees that your dishes are always spotless. You can maintain the effectiveness of your Bosch dishwasher and avert future issues by adhering to a few easy steps.

We wash the filter element

The cleaning filter that is located at the very bottom of the dishwasher’s washing chamber needs to be your focus right now. A liquid-spraying rocker arm is located nearby. If you first take out the lower dish basket and examine the chamber, finding the units is not too difficult. The trash filter’s cover is situated directly beneath the basket.

Cleaning the filter element at least once a week is crucial to preventing the "home assistant" from developing an unpleasant mold odor. Furthermore, after the working cycle, a clogged filter prevents the waste liquid from leaving quickly. The cleaning process.

• Wipe off all the water in the washing chamber.
• Remove any debris that may remain near the filter element.
• Unscrew the cover counterclockwise and remove it.
• Wash the filter and its parts using a solution of water and detergent.
• Wait until the cleaning filter dries.

Use a citric acid solution (dilute two teaspoons of acid in 200 milliliters of water) if the dirt is still there after an hour of filtering. After removing the component, give it a sponge wipe and give it a tap water rinse.

Clean the filter installation site

Proceed to the drain hole and clean the mesh filter there as well. Performing this, you ought to:

• remove all dirt from the surface of the drain;
• remove all parts from the drain and seal the hole with tape so that debris does not get into it;
• clean all components with the same sponge.

Rinse the unit very carefully to avoid pushing the sealing rubber out of place.

Similar to the last point, the parts must be soaked in a citric acid or table vinegar solution if the dirt refuses to budge.

Inlet valve

All dishwashers have a filling valve installed because it is necessary to begin filling with water for washing or to turn off the water supply to the inlet sleeve in response to a signal from the appliance’s control board. The filter that is placed in front of the valve occasionally becomes clogged by rust and other tiny debris because regular tap water is rarely pure and of high quality. As a result, the element occasionally needs to be cleaned.

• Turn off the water supply, remove the hose from the dishwasher.
• Pull out the filter element, which looks like a small mesh with tiny holes. If it does not give in, then you can remove it with pliers.
• Clean the mesh under a powerful stream of hot water from the tap.
• Install the filter in its seat.
• Conduct a small test – restore the water supply and check how the inlet valve now works.

Installing a water filter that will clean hard tap water can help you clean the inlet valve from dirt less frequently.

If the mesh is covered in scale, rust, or other impurities, it can be soaked in a citric acid solution for one hour. The section still needs to be cleaned with a sponge and then washed with clean water.

Wash the baskets from fat and dirt

Dishwasher baskets are among the final items that require maintenance. Regarding baskets, what needs to be done?

• Remove large contaminants that are stuck in the lattice elements of baskets.
• Place all baskets in a large basin, or in the bathroom.
• Foaming well and apply it to the sponge.
• Rinse all baskets with a sponge with foam, apply a remedy on them and leave it for 30 minutes.
• Wash all baskets from wet pollution.
• Remove the entire foam, rinse the elements in clean water and leave to dry.

Now that the basket has been cleaned, you can move on to the final component.

The pump also needs to be washed

Even though the drain pump can routinely operate and remove the spent liquid at the end of each working cycle, it is still susceptible to partial clogging. Even though the element can somewhat self-clean after every wash with a strong stream of water, hair, food residue, and other debris can still get on the impeller. An excessive amount of dirt can cause the impeller to spin more slowly or perhaps stop altogether. In this scenario, cleaning this unit will also be necessary.

• Disconnect the dishwasher from the power supply.
• Remove the baskets for dishes, the drain filter, and the drain pump flap.
• For convenience, move the machine away from the wall to ensure free access, and place the device on the back cover.
• Disconnect the clamps to remove the bottom.

In order to have a picture of the proper wire connections later on, make sure to remove any float sensor that may be on the bottom and disconnect the wiring before doing so.

• A pump is attached to the side of the circulation unit, from which you need to remove the screw and also disconnect all the chips with wires.
• Turn the pump and remove it from the seat.
• Clean blockages in the pump holes, if any, and also remove dirt from the hoses and pipes.

Now that the house has been thoroughly cleaned, all that needs to be done is put everything back in its proper locations and run a test work cycle.

Home remedies for dishwasher care

You must use manual cleaning, which is impossible without specialized household products, to completely remove dirt from household appliances because the self-cleaning feature is unable to do so. One of the best ways to clean the machine is to use a standard vinegar and soda solution.

• Add about 200 milliliters of vinegar to the dispenser of the dishwasher.
• Apply ordinary baking soda in an even layer to the bottom of the washing chamber.
• Start any long-term operation mode.
• When the water in the "home assistant" heats up, stop the operation using the pause key.
• Leave the machine like this for 30 minutes if it is not very dirty, or overnight if it has not been cleaned for a long time.
• Reactivate the operation when the specified time has passed.

Inside the washing chamber, dirty dishes cannot be used with this self-cleaning technique.

In addition, you can use a solution of citric acid rather than vinegar. It is not advisable to add it to the unit in large amounts though, as the acid can corrode the ion exchanger and harm the rubber seals in the washing chamber. As a result, it ought to be reserved for cleaning specific PMM units.

Maintaining the cleanliness of your Bosch dishwasher is essential to making sure it operates well and lasts longer. Food residue and mineral deposits that may impair performance can be avoided by routinely cleaning the filter, spray arms, and interior.

Simple maintenance procedures, such as cleaning the door seals and using a cleaning solution during an empty cycle, can keep your dishes immaculate and help you avoid offensive smells. In addition to saving you time and effort, a well-maintained dishwasher also lowers the need for expensive repairs.

If you incorporate these cleaning habits into your routine, your Bosch dishwasher will keep producing outstanding results for many years to come. Short-term time investment yields long-term benefits.

Video on the topic

Self-service Bosch dishwasher

How to clean a Bosch dishwasher

How to clean a Bosch dishwasher filter

Finish dishwasher cleaner