First launch and washing in the Atlanta washing machine

It’s exciting to set up your new Atlanta washing machine for the first time. Optimizing everything from the beginning can have a significant impact on how well your machine operates.

There are a few preliminary steps that you should take before starting to wash. These consist of testing the connections, completing a test cycle, and becoming familiar with the machine’s different settings.

To help you get the most out of your Atlanta washing machine right away, this guide will take you through the initial launch and washing procedure.

Whether the machine was prepared for laundry?

At last, the store delivered the new Atlant washing machine. What comes next? Make sure the washing machine is allowed to "stand" at room temperature while you read the equipment’s instructions. The user manual provides instructions on how to connect and install the washing machine correctly as well as initial startup tips.

Make sure you take out the Atlant washing machine’s transport bolts.

Each and every Atlant washing machine has transport bolts. They adjust the machine’s drum to prevent the container from colliding with other internal components while being transported. The equipment’s instructions outline the quantity and placement of the screws (four or six, depending on the model).

Included with the Atlant automatic machine are special plugs. They are inserted into the holes created by taking out the bolts. If the transport screws are left in place, the washing machine will not turn on and will eventually break. Since the user is to blame for the breakdown, warranty repairs are not covered.

Install the washing machine and connect it to the home utilities after removing the bolts. Pay attention to the equipment’s instructions. It specifies the location of the drain point and how far the drain hose should be placed from the floor. Make sure the machine body is level.

Therefore, prior to turning on for the first time, you must:

• let the machine stand for 2-3 hours at room temperature (especially if the washing machine was transported in the cold season);
• unscrew the transport bolts, put in the plugs;
• correctly connect the machine to the utilities;
• make sure that the washing machine is level;
• check that there is no foam, cellophane, tools, etc. left in the washing machine drum.

You can then begin the initial wash. Prior to anything being in the drum, a test idle cycle is initiated. We’ll explain to you why the machine must be "run" empty.

In order to ensure maximum performance and longevity, it is imperative that you carefully set up your Atlanta washing machine, do a test wash without laundry, and follow the manufacturer’s instructions to minimize potential problems and get the best washing results.

Why start the equipment with an empty tank?

Why is the first time the machine must be started empty so crucial? Large factories assemble washing machines. The components become soiled with oil and other technical liquids during the process. The equipment still contains all of the dirt.

The automatic machine is first started up with the intention of cleaning it inside and checking for leaks or other issues.

Items thrown into the drum at the beginning of the first wash will not be removed; instead, they will become soiled. There will be greasy stains, fuel oil residue, etc. on the clothing. As a result, you must first clean the washing machine’s interior and get rid of the disagreeable technical odor.

Initiating a test cycle:

• make sure that the drum of the washing machine is empty, close the hatch door;
• pour powder or liquid detergent into the cuvette;
• plug the machine into the network (you cannot use an extension cord, the washing machine wire must reach the outlet);
• select a high-temperature washing program lasting at least 2 hours;
• press the "Start" button.

The machine will then begin to operate. It is necessary to use powder or gel even though the test cycle is done without laundry. Detergent will assist in cleaning the machine of dirt.

Watch the washing machine after it has entered an idle cycle. Observe how the washing machine operates.

• fills with water;
• spins the drum (during washing, the speed should be low, during spinning – high);
• heats the water to the set temperature (this should take the washing machine 5-8 minutes);
• drains the water into the sewer pipe.

Making sure there are no leaks is crucial. Examine the drain and inlet hose connections carefully, and look beneath the machine. Keep an eye on the washing machine’s behavior while it spins and how much it shakes. The Atlant washing machine may be installed incorrectly or have a manufacturing defect if it "jumps" around the room.

If during the test cycle any issues are discovered, give the service center a call right away. Under warranty, the manufacturing flaw will be fixed. The washer will be taken in for diagnostics by the technicians, who will then resolve the issue.

A machine that is still covered by warranty shouldn’t be fixed by you. The warranty card will no longer be valid if you begin to disassemble the case or replace any of the parts. Thus, get in touch with the service center right away and allow the master to handle the diagnostics.

The machine is ready for use if the test cycle runs smoothly. You can now begin your first laundry wash in its entirety. Here, choosing the appropriate mode is crucial while keeping an eye on the contents of the drum.

Detergent for washing the insides of the washing machine

It makes sense now why the test cycle doesn’t include laundry in the drum. First, the machine is cleaned of factory dirt during startup. Additionally, the battle against disagreeable smells is waged. Which product is most effective at cleaning the washing machine’s interior?

Use of regular laundry powder or gel is acceptable. The product’s suitability for an automatic machine is what matters most. Granules for hand washing should not be poured into the tray since they produce excessive foam. Thus, check the packaging for the "Automatic" mark.

Purchasing specialized household chemicals for the washing machine’s initial start-up is preferable. Take Helfer Start HLR0054, for instance. Strong composition efficiently gets rid of any industrial contamination and bad smells.

Surfactants that work well with fuel oil, lubricants, oil, and other technical liquids are included in the product’s composition. The parts of the automatic washing machine are degreased, cleaned, and have an antibacterial effect. How to Utilize HLR0054 Start:

• Pour granules into the powder receptacle (into the compartment for the main wash);
• Select a high-temperature program for the test cycle;
• Start the wash by pressing the "Start" button.

You can also run some water through the washing machine to remove any leftover detergent if needed. Then launch the "Rinse plus spin" application to accomplish this. After that, you can begin cleaning things.

It’s simple to start your Atlanta washing machine for the first time, but to make sure everything goes as planned, you must carefully follow the instructions. By properly assembling and operating the first wash, you can extend the life of the machine and guarantee that your clothes are cleaned efficiently right away.

You can keep your washing machine in good working order and feel more confident using it for all of your laundry needs by taking the time to learn how to use it correctly. You can continue to get the best performance out of your Atlanta washing machine for many years to come with careful operation and routine maintenance.

Never forget that you can learn more about your machine’s features and capabilities with every wash. You’ll eventually figure out what settings your laundry responds to the best, which will make washing clothes a quicker and more efficient chore.

Video on the topic

Preparing the ATLANT washing machine for work

Starting the Atlant 50C102 washing machine.

The first launch of the Belarusian washing machine Atlant SMA 40 m 102

Review of the washing machine Atlant 70U1213-01 7kg

Unpacking and the first launch of the washing machine

The first launch of the washing machine

Overview of the washing machine Atlant 70U1010🌞💦 /Programs /what was surprised😮 /see carefully! 🙏

Review of the washing machine Atlant 60U1214-01 6kg