Samsung washing machine turns off during washing

You’re not the only one if your Samsung washing machine repeatedly shuts off in the middle of a load. This can be a bothersome and worrying problem, particularly if you depend on your washing machine to provide clean clothes.

Your washing machine may be malfunctioning for a number of reasons, ranging from straightforward power supply issues to more complicated internal problems. You can determine whether it’s something you can fix yourself or if you need to call in a professional by being aware of the potential causes.

In this post, we’ll look at some common causes for your Samsung washing machine to unexpectedly stop in the middle of a cycle and offer some helpful advice on how to restart it.

There are a few possible reasons why your Samsung washing machine might shut off while it’s washing, including a malfunctioning control board, overheating, or problems with the power supply. You can troubleshoot the issue and determine whether a professional repair or a quick fix is required to get your machine operating smoothly again by being aware of the potential causes.

Why the problem occurred?

Should your Samsung washing machine abruptly shut off in the middle of a cycle, it might have been caused by outside influences that you were unaware of. Prior to seriously diagnosing the washing machine’s internal components, you should first check the most fundamental things. Examine the external electrics first.

• Maybe you left, and during this time the electricity was turned off in the house? Maybe the light went out in the entire apartment or only in the room where the Samsung washing machine is located? You also need to check the electrical panel.
• If the previous points have been checked, then pay attention to the outlet to which the machine is connected.
• Finally, carefully examine the washing machine cord, whether it has been bitten by a dog, whether there are any visible defects on the plug.

The Samsung washing machine may shut off in the middle of the cycle for any of these three most common malfunctioning reasons. In the event that any of these occurred, the malfunction can be fixed easily and promptly. However, deep diagnostics and repair will be necessary if the "home assistant" stopped working because of damage, a stuck network button, an electronic module malfunction, or a breakdown of the interference suppression filter.

Interference suppression filter and wiring in the CM

What should I do if the socket and cord are in working order and the light was not switched off while the Samsung washing machine was operating? Before diagnosing complex parts of household appliances, you should first check their simpler components. Examining the network cable, plug, and interference suppression filter should be our first step. Since these components are interconnected, they will be examined all at once. To disassemble the components, adhere to the instructions.

• Disconnect the washing machine from all communications.
• It is advisable to move the device away from the wall so that there is free access to the back wall of the machine.
• Remove the screws securing the top cover of the equipment.
• Find the interference suppression filter, most often located slightly to the left of the place where the power cord is connected inside the Samsung washing machine body.
• Now you need to loosen the clamp that holds the power cord.
• It remains to pull out the filter and the power cord.

Once the assembly is complete, you must carefully examine the wire plug. Take a multimeter, set it to the resistance measurement mode, and attach the probes if there are no obvious flaws. A zero value indicates that the tester is operational and prepared for diagnostics.

Use the probes to examine each core of the power cord after turning the tool to buzzer mode. If there is a proper connection between the wire sections that have been tested, the tester will beep each time. The wire is obviously broken if the device is silent.

Make sure to unplug the cord from the power source before checking any wire that is under voltage.

In this instance, repair won’t have the desired outcome. Blue tape should not be used or twisted in order to repair the Samsung washing machine wire. Simply purchasing a new cord will prove to be more cost-effective and ensure that a break or short circuit won’t occur again anytime soon.

Using the same multimeter in buzzer mode, you should check the filter after the wire. If the element displays 0 or 1, it needs to be thrown away. Attach the tester probes to the capacitor contacts. Purchase the exact same filter that you took out of your "home assistant" to avoid wasting money.

It’s critical to take immediate action to fix a malfunctioning Samsung washing machine in order to prevent additional damage. Make sure the outlet is working properly and the plug is firmly inserted before inspecting the power supply.

Next, look for any indications of an overloaded drum or overheating in the washing machine, as these conditions can also result in an unplanned shutdown. It could be helpful to decrease the load size or let the machine cool down.

Investigating more technical causes, such as problems with the control board or internal wiring, may be necessary if the issue continues. In this instance, the best line of action to avoid more serious malfunctions is to seek professional assistance.

Video on the topic

The reason for the accidental shutdown of the Samsung washing machine

SAMSUNG WW60J4260HW1 washing machine. Dull, turns off during operation. The truth about the ECO mode.

Samsung washing machine turns off

Samsung WF0408S1V washing machine – spontaneous shutdown and on of the SMA during washing!

Samsung washing machine turns off during washing

Samsung Eco Bubble washing machine turns off during washing

The washing machine starts and stops.

The machine stops during washing